By using `BOOT_CFG_AUTOBOOT_EN` in `boot_cfg` and `EXTRA_CFG_NYX_UMS` in `extra_cfg` you can launch UMS from boot.
The `ums` variable must be populated with one of the following:
```
NYX_UMS_SD_CARD 0
NYX_UMS_EMMC_BOOT0 1
NYX_UMS_EMMC_BOOT1 2
NYX_UMS_EMMC_GPP 3
NYX_UMS_EMUMMC_BOOT0 4
NYX_UMS_EMUMMC_BOOT1 5
NYX_UMS_EMUMMC_GPP 6
```
Using the key `emupath` on a boot entry will load the selected emuMMC.
This can also be forced by using the correct boot cfg storage bit and writing the path at the emummc path offset. Check readme for these.
This can only be used if the emuMMC was created via Nyx. because of the raw_based and file_based files that have emuMMC info.
(emupath=emuMMC/RAW1, emupath=emuMMC/SD00, etc)
It will now show erros for the following:
- Missing or old libsys_minerva.bso (DRAM training).
- Missing libsys_lp0.bso (LP0 sleep mode).
- Missing or old Nyx version
This is conditional:
In order to not cancel booting while trying to enter fastboot in android, the combo MUST be initiated with `VOL+` (hold) -> `VOL-` (hold)
- Training and switch is now faster
- Compatibility checks: New Minerva does not allow old binaries. New binaries do not allow old Minerva
- MTC table is now in a safe region
- Periodic training period increased to every 250ms
By using the key `id=` with a max 7 ASCII id, hekate will search all inis automatically and pinpoint the boot entry with that id.
After that it forces a boot from this one.
- Use always aligned buffers to up the speed for DMA usage. For verification, backup and restore.
- Rework verification a little bit and make default Sparse mode.
Sparse mode protects from fake sd cards, bad sectors and frequent I/O corruption. Aka, ~100% of cases.
- Make debugmode for exosphere mandatory
- Support dev RSA modulus for warmboot
- Fix a critical bug where it allowed free() to be used on a non-heap address.
- Better the makefile
- Still compatible with old hekate.
- Allows for hotfix control
- Sept is now copied from actual running payload, negating the need to check update.bin
- If a foreign payload is found in sept then it is renamed and hekate copies itself. After sept run, it renames it back and continues with boot.
- Allow no hekate_ipl.ini and create it at 1st hekate boot
- Show Payloads/More configs options when no boot entry in main .ini
- Fix black screen on empty ini/payload folders
- Fix some stack corruption with freeing ini lists (wip)
Currently bpmp loses access to the relevant registers when secmon or exosphere is launched.
This change provides support for all firmwares and properly sanitizes the display.
